Page 1 of 1
Bingolette ... Part missing!
Posted: Wed Nov 04, 2020 10:46 pm
by daveslot
Just dug out a Bingolette from storage, cleaned up very well but didn't pay out. Noticed a gap on the mechanism, presume it's a solenoid unit missing. Would this be the culprit? Anybody got any breakers around for a spare or is there a work-around?
Re: Bingolette ... Part missing!
Posted: Thu Nov 05, 2020 6:37 am
by santelmann
There should be a group of 3 relay units...
-Payout
-Reset
-Anti cheat
One is missing
Re: Bingolette ... Part missing!
Posted: Thu Nov 05, 2020 12:29 pm
by pennymachines
It's the payout relay.
Re: Bingolette ... Part missing!
Posted: Thu Nov 05, 2020 5:30 pm
by brigham
If the 'anti-cheat' relay has the same number of contacts, you may be able to press it into service as the missing 'payout' one.
Re: Bingolette ... Part missing!
Posted: Fri Nov 06, 2020 4:17 pm
by daveslot
i suspected it was the payout soleniod as it was not payout out! typically i had got rid of a few others because they had poor cases
the anti cheat does look similar to the payout, how does the anti cheat work, what sets it off