Duomat penny slot machine

[coppinpr]

I'm searching on my computer for the sticker kit, but as yet it's lost in the maze. It was some years ago. I'll find it, give me time. Do not remove the old ones as yet, I may need the measurements to create a new set for you later.

The problem with the back door is... it's not a back door, it's a half cabinet about the same size as the front half (see one of my photos earlier). Even with the back half they tend to fall over when you work on them. Best way by far is to remove the mech which comes out in one piece very easy (I think 3 wing nuts and a couple of cir-clips and it's out). Then you can work on the case easy and the mech easy as it stands up nicely on its own.

[mei-mei]

Thanks, helpful. Still need the other half (door) though or the mech might get damages with use.

[badpenny]

I may have the frame for the back bit, probably tatty as hell, but it's a start.

BP

[mei-mei]

BP you are a life saver! I can deal with the cosmetics not a prob. How do we proceed? Mei-mei

[mei-mei]

P.S. BP, I have attached a pic of the mech attached to the handle at bottom of the machine. It would seem it is missing a part where the rod attaches. Might you also have one of these?

[coppinpr]

How do we proceed?

1st thing is you have to laugh at BP's jokes. It's not easy but pays dividends

[mei-mei]

Wow you wanna make this really hard. Ok, he he he he he

[badpenny]

P.S. BP, I have attached a pic of the mech attached to the handle at bottom of the machine. It would seem it is missing a part where the rod attaches. Might you also have one of these?

This really is your lucky day!
I'm aiming to collect all my babies Sun 18th December.

[mei-mei]

All hail BP all hail BP!!!!!

[badpenny]

I was running out of room in the truck, so didn't get to load all of my machines, but remembered to dig out the "gash" Duomat.
Turns out it has 3 sides of the front case but none of the rear part - sorry
The mech is lacking payout tubes, slides and clock - but I seem to recall you're ok on that front.

I think it's the handle and gubbins you need.

Look at the photos and have a think.